Winter preventive maintenance for your heating system

Many homeowners and heating and cooling service companies overlook preventive maintenance for the winter months. It’s just as important to check a heat pump system before the wintertime as it is before the summertime, to maintain reliable and effective performance.

Here is the list of some but not all of the steps that a company can and should check during the preventive maintenance inspection.

Indoor Unit Inspection
When inspecting the indoor unit, be sure to check the air filter and electrical connections, and clean the coil. The following information is a useful guideline for proper indoor unit inspection:

Inspect the air filter. Depending on the condition of the filter, clean it or replace it with a new one.
Inspect the electrical wires to ensure a tight connection exists. Loose connections can cause wires to overheat and burn up.
Oil the blower motor or bearings if necessary. Inspect the blower wheel for balance and cleanliness.
Inspect and clean the indoor coil and drain pan.Use a cleaner that’s suitable for indoor coils.
Flush and clean the drain line. Remember to prime the trap, if necessary.
Turn on the auxiliary strip heat for inspection. If the unit uses electric heat, check all of the wiring for discoloration and heat damage. Replace all damaged wires.
Check the amperages of the electric elements. Verify the elements are staging on properly and shutting down properly.
For dual-fuel applications, conduct the appropriate preventive maintenance for gas furnaces.
Outdoor Unit Inspection
A well-maintained condensing unit coil is vital to proper heat pump operation. Other outdoor unit maintenance includes:

Inspect the condensing unit’s base-pan drain holes and remove any debris.
Check the unit’s wiring connections and the wiring insulation. Repair any damage.
Oil the condensing-fan motor, inspect the fan blade for any damage, and balance.
Verify the outdoor temperature sensor(s) are in the proper location.
Thermostat
The thermostat is an essential element of the heat pump system. Be sure to include it in your winter maintenance inspection. Verify all connections are tight on the sub-base of the thermostat and that the thermostat is level.

General Operation Maintenance

Turn on the system at the thermostat. Hookup your gauges at the condensing unit.
Measure and record the suction line pressure and discharge pressure of the system. Get a proper superheat and sub-cooling reading. The reading can help you determine if you need to troubleshoot any issues with the refrigeration system.
If necessary, check and adjust the charge in the system. Refer to the manufacturer’s charging instructions for the proper charge. If the unit is low on refrigerant, locate and repair the leak in the system.
Initiate a defrost cycle and check with the manufacturer’s instructions for the proper defrost sequence.
Check the operation of the indoor unit. Check and verify the supplemental heat is operating normally.
Inspect the duct work for any damage.
Preventive maintenance of heat pumps can lead to peace of mind for the homeowner. Many potential problems can be alleviated, and it may stop you from receiving late night maintenance calls when it’s cold outside.